The Airtech Molds Aren't Dead Yet

I figure a couple of you might be interested in this email I just received. It appears Gustaffson Plastics has purchased 7,000 of the Airtech molds.

 

That's awesome.... hopefully they can keep them (relatively) affordable

 

That is great news for vintage bike owners!

 

St Augustine? That's only an hour's drive North from here! And I have a good buddy & VFR owner who lives there!

I think I found their website:

https://bikescreen.com/pages/search-results-page?q=air tech

 

Sweet!! Can't wait till they get the 1st gen seat cowl going! Too bad it is in Florida. Dead opposite of where they were manufactured dangit!

 

Florida is a lot better than the literal dumpster most people expected they were headed for!

 

True dat! I hope the shipping is not too bad.

 

Why is it 'too bad it is in FL'?

 

Rogue was looking to save on shipping via local pickup.

 

Literally I could have drove down in a couple hours to save $500 + on shipping. And my wife would have been fine coming along to chat my ear off with no escape!
There is no intended hate on Florida, I have actually considered moving there.