Need help with Laser exhaust

Blurrrrrrr....................

That is cold:biggrin:

 

I don't know

BZ, Not sure if it sound good......They not event install yet:biggrin:

 

In due time

I am try to be nice , Laser may take care of it yet, but when I am done I shall be an asshole. Put the whole thing on the back burner and kinda forgot about it for a bit. Had bigger fish to fry the last couple of months but this is the fish in the fire now.

 

Wow fitment is better then i had thought j/k. I had similar fitment issues with my LV but after tinkering with pipe layout for a couple of hours i got them close enough to perfect.

 

Fitting the pile

I thought the same thing when I started, but this shit is hopeless.Way tooo far off. Really, not even close.

 

F'n pic's

Would have really thought one of you would have posted some pics by now........not alot to ask.

 

And the left side...


Sorry it took so long. There must be a flaw in the bend of your pipes. There isn't a lot of room for error and the only corrections I had to make were different number of washers in the hangers to make the pipes symmetrical on both sides. The angles still aren't exact as far as up/down but its minimal. Hope this helps. Let me know if you need more. Oh and don't mind the dirt...or the spider. Contrary to the pics I do ride the bike, but usually only when it rains or below 50 degrees.

 

Thanks

If I get stuck with this thing your pic's are very helpful.It would have to be the left side pipe and not the Y pipe from looking at you pic's. The one I have points into the right side pipe just above the first bend and the one on you bike has a much more mild bend to it . If my Laser nightmare gets to the point where I cut and tig it to fit this is gonna help alot. Thanks.